Mounting Bracket and Solar Panel Installation:
Assembly Sequence: First assemble the solar panel mounting bracket, then fix the solar panel. Adjust the angle and tighten the bolts.
Fixing Method: For pole mounting, use U-shaped clamps to fix the photovoltaic panel. For simple installation, 3M adhesive or expansion screws can be used to fix the base.
Spacing Requirements: It is recommended to maintain a 50cm gap between the camera bracket and the solar panel mounting bracket to avoid mutual obstruction.
Camera and Wiring:
SIM Card Installation: Insert the 4G data SIM card (chip side facing away from the camera) and memory card (chip side facing inward) into the corresponding slots. After hearing a "click," replace the waterproof cap.
Wiring Connection: Connect the solar panel cable to the controller or camera interface, paying attention to the positive and negative terminals (some devices support blind insertion). Seal the interface with waterproof tape.
Equipment Fixing: Fix the camera to the bracket, adjust the horizontal and vertical angles, and ensure that the vertical error of the pole is ≤0.5°.